当前位置：
首页 资源下载
搜索资源 - power factor matlab
搜索资源列表
-
0下载：
This program is to calculate the Reciving End MVA Power for transmission overhead line 220KV
-
-
3下载：
基于平均法的boost型DC/DC建模步骤，包括电压模和峰值电流模。增加了误差放大器放大倍数的确定，电源调整率，负载调整率和三种变换器的一阶等效模型,Based on the average of the boost-type DC/DC modeling steps, including the voltage mode and peak current mode. An increase of the error amplifier to determine the magnificatio
-
-
4下载：
此乃用MATLAB进行PFC（功率因数校正）的simulink模型，对PFC的建模，非线性分析和参数设定具有重要作用！-This is to use MATLAB to PFC (Power Factor Correction) in simulink model of PFC modeling, nonlinear analysis, and parameter setting plays an important role!
-
-
0下载：
基于matlab的有源功率因数校正仿真，含电路仿真图-Matlab-based simulation of active power factor correction, including circuit simulation map
-
-
1下载：
基于matlab的单位功率因素校正（PFC）仿真-Matlab-based unit of power factor correction (PFC) simulation
-
-
3下载：
MATLAB做的STATCOM，用于无功补偿和功率因数校正-power factor corrector using statcom
-
-
0下载：
power factor correction of AC to DC converter ,simulation with Matlab.
-
-
1下载：
用DSP实现高功率因数PWM整流器的控制，采用2407控制-Using DSP to achieve high power factor PWM rectifier control, the use of 2407 control
-
-
0下载：
Performance at the unity power factor for a 5 bus power system. This is used to investigate the the load flow algorithm developed based on Gauss Seidel method.
-
-
0下载：
基于平均法的buck_boost型DC/DC建模步骤，包括电压模和峰值电流模。增加了误差放大器放大倍数的确定，电源调整率，负载调整率和三种变换器的一阶等效模型-Based on the average law buck_boost type DC/DC modeling steps, including the voltage mode and peak current mode. An increase of the error amplifier to determine the magni
-
-
0下载：
计算SENSE重建图像中的g-factor,这是并行磁共振成像SENSE算法的关键一步-G-factor is the metric to quantify the amplificaiton of noise power in reconstructing SENSE accelerated image. The detail was presented in Pruessmann s 1999 Magn. Reson. Med. paper. In theory, g-factor is t
-
-
0下载：
基于单位功率因数控制策略的单相有源滤波，去掉非线性负载部分即为单相全控整流。开关器件采用IGBT。-Based on the unity power factor control strategy of single-phase active power filter, remove the part of non-linear load is the single-phase full-controlled rectifier. Switching device IGBT.
-
-
1下载：
基于单位功率因数控制策略的三相全控整流。开关器件采用IGBT。PWM波形产生控制电路里使用的饱和限制模块，就是限制波形的幅度的，对输出直流电压幅值影响很大。-Based on the unity power factor control strategy of three-phase full-controlled rectifier. Switching device IGBT. PWM waveform generator control circuit in the saturation
-
-
0下载：
simulation of 24 pulse isolated. it is the best compared with 12 pulse and below in power factor. it can be achieved with 12 pulse and simple pulse doubling circuit.
-
-
0下载：
原创源码。P-Q方法的功率因数计算matlab仿真。-resource about P-Q method power factor calculation
-
-
4下载：
基于PSIM仿真软件，AC-DC变换，功率因数校正使用集成芯片UC3854进行仿真。-PSIM simulation software based, AC-DC conversion, power factor correction IC UC3854 using simulation.
-
-
0下载：
对一种三相无源功率因数校正电路进行了参数的优化和仿真，仿真结果表明，运用Matlab中的SimPowerSystems模块对复杂的电路进行仿真分析和研究，不失为一种准确、直观有效的方法。 -Of a three-phase passive power factor correction circuit parameter optimization and simulation results show that the use of Matlab in SimPowerSystems modul
-
-
0下载：
this the model of power factor correction by matlab program-this is the model of power factor correction by matlab program
-
-
0下载：
此仿真实现了三电平的有源逆变，且功率因数可调-The simulation of the three-level inverter, and active power factor can be adjusted
-
-
0下载：
This a matlab that contain the circuit of the power factor. It is in 3 phase. -This is a matlab that contain the circuit of the power factor. It is in 3 phase.
-
